|
If your meter has dual relay output capabilities, follow the steps below to select values for Setpoint 1 and Setpoint 2. 1. Press the SETPTS button. The meter momentarily shows "SP1" (Setpoint 1), followed by the last stored value with flashing 4th digit. The factory default for "SP1" is 000.0. 2 Press the /MAX button to change the value of Setpoint 1. 3. Press the  /MIN
button to scroll to the next digit.4. Press the SETPTS button to store your selection. The meter momentarily shows "SP2" (Setpoint 2), followed by the last stored value with flashing 4th digit. The factory default for "SP2" is 000.0. 5. Press the  /MAX
button to change the value of Setpoint 2.6. Press the /MIN
button to scroll to the next digit.7. Press the SETPTS button to store new values. The meter momentarily shows "STRD", "RUN" and then enters the run mode. Note 1: You may press the RESET button anytime during this routine to return to the run mode. Note 2: If your meter does not have dual relay output capabilities, the SETPTS button's only function is to display "RUN" and return the meter to the run mode. |
